– 4-board LED, White backlight, light uniformity
– PCB Size: 45 (mm) x 45 (mm)
– The corners were positioning holes, along with two rows of the upper and lower connection port, ranked as follows:
VCC – power input ( 3.3v )
GND – Ground
SCE – Chip Select
RST – Reset
D \ C – data / instruction selection
DN – Serial Data Line
CLK – Serial Clock Line
LED – backlit console
– Power supply voltage:2.7V-3.3V,5V is OK,but part of the screen becomes black when tested.
– Data interface level:2.7-5V.
– Backlight power supply voltage:highest 3.3V.
– Installation diameter:2mm.
– 84 X 84 dot matrix LCD,can show 4 lines of characters.
– Use serial interface communicate with the master processor,the number of interface signal line reduced greatly, only 8 signal lines including power and GND.Support different types of MCU,such as the SPI,MCS51 serial mode 0 of – AVR.Transfer rate up to 4Mbps,can full speed write display data without waiting time.
Can use the conductive glue to connect the module with the printed board,without connecting cable.The metal hooks on the module can fix the module on the printed board,which is very easy to install and replace.
Alamat (RT RW Kel. Kec. Kode Pos) :
No. HP :
Kode/SKU (jumlah) :
SMS/WA : 0856-480-22-313
BBM : D2E.7711.B
LINE ID : pusatkomponen
Jl. Prambanan No.877, Ruko ABCDEFG, Banyuwangi - Jawa Timur, Indonesia